To re-bind the transmitter and receiver for the FMS 1:24 FCX24M Land Rover Camel Trophy Edition RC car, follow these steps:
-
Turn off the Transmitter and Receiver: Ensure both the transmitter and receiver are powered off.
-
Enter Bind Mode:
- Transmitter: Hold down the bind button on the transmitter while turning it on. The LED indicator on the transmitter will start flashing, indicating it is in bind mode.
- Receiver: Power on the receiver while holding the bind button on it. The receiver's LED will also start flashing, indicating it is in bind mode.
-
Establish Binding: Release the bind button on both the transmitter and receiver. The flashing LEDs on both devices should become steady, indicating a successful binding.
-
Test the Connection: Turn off both the transmitter and receiver. Then, turn on the transmitter first, followed by the receiver. Check if the RC car responds to the transmitter's controls to confirm the binding was successful.
-
Troubleshooting: If binding fails, repeat the steps ensuring proper timing and button presses. Ensure the transmitter and receiver are compatible and within the proper distance for binding.
These instructions will help you re-bind the transmitter and receiver of your FMS 1:24 FCX24M Land Rover Camel Trophy Edition RC car .
FMS Official website：https://www.fmshobby.com
FMS Customer Service Hotline：(+1) 8504480101
FMS Service Email：support@fmsmodel.com
Comments
1 comment
I tried it about 20 times and it would not function. Forever it stopped working i got a beep from the transmitter, like it had no signal and was shutting down.
Please sign in to leave a comment.