Reflex V3 Causes Controls to Go in the Opposite Direction

Question: My Reflex V3 causes controls to go in the opposite direction. What should I do?

Answer:

1. Check the Model Selection on Reflex:

   • Reflex V3 allows users to select the specific model of their aircraft. Ensure that the correct model is selected. An incorrect model selection may result in controls operating in the opposite direction.
     

2. Check the Installation Position of Reflex on the RC Plane:

   • The installation position of Reflex V3 is crucial for its proper operation. Ensure that Reflex V3 is not installed in a reversed or incorrect angle. Proper installation should follow the instructions in the manual to ensure that the sensors accurately detect the aircraft's movements.
     

By following these steps, you should be able to resolve the issue of Reflex V3 causing controls to go in the opposite direction. If the problem persists, please refer to the Reflex V3 user manual or contact technical support for further assistance.

FMS Official website：https://www.fmshobby.com
FMS Customer Service Hotline：(+1) 8504480101
FMS Service Email：support@fmsmodel.com