FMS 1:10 FCX10 Chevrolet K5 Blazer RS 【TH.REV】is not working as throttle reverse.
1. Refer to the instruction manual for guidance.
2. We need to adjust the 【TH.TRIM】arrow to be vertically downward and the other knobs to be centered as well. Currently, the settings on the remote control have become scrambled, we need to reset them.
How to reset:
To restore to the default value, press the BlND and CH4 buttons of the transmitter at the same time, and power the transmitter on. At this time, the buzzer will give a long beep.
Note 1: This function is only applicable to resetting the endpoint value set to the default value.
Note 2: After resetting, the previous binding settings will no longer be in effect. Therefore, we kindly need to reset the rebound again.
follow the steps below to rebind. The transmitter supports two-way binding, the steps are as follows:
1. Turn on the transmitter while holding the BIND button, then the transmitter will enter the binding mode. At this time the G.LED will flash quickly, Once in bind mode release the BlND button.
2. Turn on the receiver, and it will wait for 1 second for connection. lf without connection, the receiver will enter the binding mode automatically.
3. Once the binding is successful, the receiver LED and the G.ED of the transmitter will be solid.
4. Verify that the transmitter and the receiver are working properly. If you need to re-bind, repeat the above steps.
Notes:
1. Applicable to the FS-MG11-BS transmitter and the FS-R11D-ESC-BS receiver.
2. The FS-MG1 1-BS transmitter complies with the 2A-8S protocol and is only compatible with receivers conforming to this protocol.
3. Different receivers have different bind procedures. For more information, visit the FLYSKY website for manuals and other related information.
3. In the video, the TH.TRIM on the remote controller is not set to the center and has been adjusted to the maximum, causing the car to lose control.
Similar case videos:
FMS 1:10 FCX10 Chevrolet K5 Blazer RS 4WD is not working videos
FMS Official website:https://www.fmshobby.com
FMS Customer Service Hotline:(+1) 8504480101
FMS Service Email:support@fmsmodel.com
Comments
0 comments
Please sign in to leave a comment.